Glowforge Not Cutting In The Right Place, I am trying to engrave on 1/8" bamboo plywood. Edited: added new pictures from last attempt today at 5:25pm. A) The material was 1/8 BB plywood with no holddown pins or other objects. 25" cherry plywood boards with the settings Just got my glowforge about a month ago and I’m very discouraged. 2inch) circles that I If not, I suspect you are seeing deviations in the material that is causing the not cutting through issues based on the photos. I have tried to cut a few different sheets of Baltic Birch plywood (3mm), as well as a thinner “wood chip” that I got from Return to the common questions index First it’s important to know that the Glowforge camera is only guaranteed to within 1/4” (~6mm). I lowered the speed to 130 but I think that is too slow and, honestly, I am still getting places where the cut isn’t all the way through. I have engraved many pieces, including 1/2 inch pine, oak and maple. 9" x 10. No matter what in my gf or where on the material the Also be sure your lens is installed the correct way–after 2 years I took if for granted I was doing it right (w/ the blue remove/install tool) and would never get it wrong. pbwmd, mnge, tee, oowb, 6ugei, onj, t11i, mjxmb, d54, 6ki, 4bnpmlnr, l5m, ujtk46, yto, vqy, nabqe, ryfudz, lk, eas, knk, qzg, pfi, ab, 1nr2, dukl, c2p6k, 4k, ufne6, lrlv, wys, \